Ball Bearing Router Bits

Ball Bearing Router Bits, Router bit, 3/8" dia.
Router bit, 3/8" dia. Item # 0583 In stock, ready to ship!
$37.72
Ball Bearing Router Bits, Router bit,1/2" dia.
Router bit,1/2" dia. Item # 0693 In stock, ready to ship!
$42.15
Ball Bearing Router Bits, Extra bearing for 3/8" bit
Extra bearing for 3/8" bit Item # 1288 In stock, ready to ship!
$9.45
Ball Bearing Router Bits, Extra bearing 1/2" bit
Extra bearing 1/2" bit Item # 1289 In stock, ready to ship!
$8.95
Ball Bearing Router Bits, Set of 2
Set of 2 Item # 0565 In stock, ready to ship!
$79.87
$69.98
Original:
$
Save:
$
Total:
$
Qty:
Please enter a quantity

Ball Bearing Router Bits

Special bits for templates! Extra-long carbide-tipped router bits produce clean, precise body cavities when used with our templates.

The ball-bearing guide matches the cutting diameter, and the long shank allows multiple-pass routing for deep cavities.

The 1/2" diameter bit is recommended for most of your routing chores, and comes with 1 bearing. Use the 3/8" cutter only for routing corners that need the tighter radius, it comes with 2 bearings.

Sold individually or SAVE when you buy the set of both router bits.

Shank diameter: 1/4" (6.35mm)
Cutting height: 1/2" (12.7mm)

A heat-resistant sleeve (not shown) holds the bearing in position. We recommend stacking an extra bearing on the shank for deep cavities, and use the 3/8" bit only for routing corners.

Tip: We recommend that you change the position of stacked bearings on the router bit's shank every time your re-chuck in the bit into your router. This will greatly extend the life of the bearings and reduces the risk of a bearing "blow-out."

California Proposition 65 Warning
Cancer and Reproductive Harm