StewMac Tape Op Delay Pedal Kit

StewMac Tape Op Delay Pedal Kit

The warm sound of tape delay in a pedal
Now you can get the unmistakable sound of an analog tape delay with the reliability and flexibility of a digital circuit.

We love analog tape delays! The raw, warm, and unique sound compliments the tone of electric guitars so well. The only problem is that tapes wear out, and analog delays can be inconsistent and difficult to dial in to the perfect sound for you. We set out to take the things we loved about classic delays and create a circuit that would be easy to use and sound killer too.

Don't buy your next pedal—build it!
We worked hard and finally developed a delay that rivaled our favorite tape machines and priceless analog pedals. No cold, sterile repeats here—the dry signal path is all analog! With 30ms to 625ms of delay you can cover everything from rockabilly slapback to deep experimental soundscapes all in one great sounding package.

With knobs for time, repeats, mix, and tone it's easy to dial in subtle or more extreme delays. The tone knob gives you complete control over the sound—you'll never have to deal with the dark and muddy sounds that ruin other delay pedals.

It's more than just a schematic
We include everything you need to build your new pedal:

• Top quality components from resistors to switch
• Road-worthy rugged metal enclosure with all holes pre-drilled
• Bare or powder coated white finish
• 3PDT breakout board for low noise
• Input, output, and power jacks rear mounted for easy cable routing
• True bypass switch
• Custom printed labels

Easy! Download your instructions
We've made these instructions ready to download now. You can zoom in on every solder joint and resistor value to make sure your build is perfect from start to finish. With these step-by-step instructions, full color illustrations, and complete wiring guide you'll build a pedal you'll enjoy for a lifetime. Be proud every time you step on the custom pedal that you built.

Make your pedal your way
It's never been easier to have an inspiring sounding and looking pedal. We include labels for all of the knobs for a professional look. Paint your own raw metal enclosure or choose a powder coated enclosure that is ready to put on your board now. Take the first step to customize your sound.

Powered by a 9 volt power supply with a 2.1mm negative-center barrel, available separately.