StewMac Two Kings Boost Pedal Kit

StewMac Two Kings Boost Pedal Kit, With Bare Enclosure
With Bare Enclosure Item # 12255 In stock, ready to ship!
StewMac Two Kings Boost Pedal Kit, With White Enclosure
With White Enclosure Item # 12255-W In stock, ready to ship!
D'Addario Planet Waves 9V Power Adapter
D'Addario Planet Waves 9V Power Adapter Item # 10669 In stock, ready to ship!
Please enter a quantity

StewMac Two Kings Boost Pedal Kit

Can't wait 5 YEARS for an Analogman King of Tone? Now you can build a pedal that captures the tone of the amazing original. Raved about by players like John Petrucci, Gary Clark Jr, Samantha Fish, and Warren Haynes, you no longer have to wait to add it to your rig.

Inspired by a heavily-modded Marshall Blues Breaker, this 2-in-1 pedal is something completely different. It's transparent but still warm and gritty, with a full range of frequencies available, all while keeping the core tone of your guitar and amp.

Don't wait! Build it now
We're not that patient! We wanted to make a pedal that was faithful to the original, but you could get your hands on it now. After months of dialing in the sound, we finally captured it. Now you can open the box and handwire yours in a weekend!

Two pedals in one
The two sides of the pedal are completely independent—it's easy to find the sweet spot for each side. With knobs for gain, volume, and tone you can get anything from simple boost, gritty overdrive, and even distortion in a flash. No matter the setting, it won't overpower the unique tone of your guitar and amp—it just makes it better. 

If you want to go deep, you can further tailor the sound with the internal controls for infinite tone tweaking.

Designed with the beginning pedal builder in mind
We include everything you need to build your new pedal:

  • 40 page step-by-step instructions written for the first time builder
  • Top quality, high tolerance components from resistors to switches
  • Road-worthy rugged metal enclosure with all holes pre-drilled
  • Bare or powder coated white finish
  • 3PDT breakout board for low noise
  • Internal DIP switches and trim pots for tone shaping
  • Input, output, and power jacks rear mounted for easy cable routing
  • True bypass
  • Custom printed labels

Nobody does instructions like StewMac
This is a fun project where you'll learn a lot and build an incredibly hard to get pedal. You'll see every solder joint and resistor value to make sure your build is perfect from start to finish. And if you get stuck, our team is here to help! Be proud every time you step on the custom pedal that you built.

Make your pedal your way
It's never been easier to have an inspiring sounding and looking pedal. We include labels for all of the knobs for a professional look. Paint your own raw metal enclosure or choose a powder coated enclosure that's ready to put on your board now. Take the first step to customize your sound.

Powered by a 9 volt battery or 9 volt power supply with a 2.1mm negative-center barrel, available separately. 

Battery saver! The included stereo input jacks acts as a switch for the battery so that you don't drain power unless a cable is plugged in.

California Proposition 65 Warning
Cancer and Reproductive Harm