Mighty Mite Neck for Tele Guitar

Shaped, inlaid, fretted and finished—feels and plays great! Hard rock maple finished in clear satin polyurethane, with an inlaid "skunk stripe" down the back.

The frets are nicely finished, and the slotted nut is shaped from PPS plastic with a flat bottom. Maple, Indian Rosewood, or Indian Laurel fretboard with dot inlays and side markers.

Mighty Mite Neck for Tele Guitar, With Indian Laurel, 10mm Pegholes
With Indian Laurel, 10mm Pegholes Item # 5712 No longer available
$159.99
Sold out
Mighty Mite Neck for Tele Guitar, With Indian Laurel, 10.5mm Pegholes
With Indian Laurel, 10.5mm Pegholes Item # 102282 In stock, ready to ship!
$159.99
Mighty Mite Neck for Tele Guitar, With Maple, 10.5mm Pegholes
With Maple, 10.5mm Pegholes Item # 102284 In stock, ready to ship!
$159.99
Original:
$
Save:
$
Total:
$
Qty:
Please enter a quantity

Mighty Mite Neck for Tele Guitar

Shaped, inlaid, fretted and finished—feels and plays great! Hard rock maple finished in clear satin polyurethane, with an inlaid "skunk stripe" down the back.

The frets are nicely finished, and the slotted nut is shaped from PPS plastic with a flat bottom. Maple, Indian Rosewood, or Indian Laurel fretboard with dot inlays and side markers.

Indian Laurel (Terminalia elliptica) is a great alternative to rosewood that can be shipped worldwide. It has a similar dark brown appearance to Indian Rosewood, with a slightly more porous texture and occasional light colored grain lines.

Screwholes for attaching to the body are not drilled. Each neck has a single-action truss rod with a 4mm adjusting nut at the peghead. We recommend Allen Truss Rod Wrench for adjusting neck relief.

Peghead is drilled for 6-in-line tuning machines. See all tuners.

More specifications:
 
Scale length 25-1/2" (647.70mm)
 
Width at nut 1-5/8" (41.28mm)
 
Width at 21st fret 2-3/16" (55.56mm)
 
Fretboard radius 9-1/2" (241.30mm)
 
Fretwire .045" high x .095" wide (1.14mm x 2.41mm)
 
Fret count 21
 
Approximate heel length 3-5/8" (92.07mm)
 
String post spread 4-11/16" (119.06mm)
 
Peghole size 10.5mm
 

The skunk stripe is the same wood as the fingerboard for necks with Indian Rosewood and Indian Laurel fingerboards. Necks with maple fingerboards have merbau wood skunk stripes.

Neck thickness (approximate; not including fret)

Mighty Mite Neck Snippet.gif

Mighty Mite Guitar Neck Pocket Snippet-5715.gifIdeally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.

These necks are made for us by Mighty Mite®, and have peghead shapes licensed by Fender®.
Telecaster®, Tele®, and Esquire® are registered trademarks of Fender Musical Instruments Corporation.
California Proposition 65 Warning
Cancer and Reproductive Harm