Please see our COVID-19 Statement
Oak Grigsby 4-way 2-pole Lever Switch

Oak Grigsby 4-way 2-pole Lever Switch

Oak Grigsby 4-way 2-pole Lever Switch

Item # 2002
In stock, ready to ship!

$16.18

+
 
Total:
Qty:
Scroll to Top

Oak Grigsby 4-way 2-pole Lever Switch

About This Item

A popular mod for Tele®!
Adds a fourth "fat tone" selection.

Along with the three standard pickup selection positions (bridge / bridge+neck / neck), it adds a fourth position that combines the bridge and neck pickups in series, for a fatter tone. Black "barrel" and "top-hat" knobs, mounting screws and wiring diagram included.

Specifications
Body cavity depth required 1-7/16" (36.51mm)
Mounting screw spacing 1-5/8" (41.28mm)
Lever stem .050" x .190" (1.27mm x 4.82mm)
Pickguard slot required 1/16" x 1-1/16" (1.59mm x 26.99mm) (for the lever)



CALIFORNIA PROPOSITION 65 WARNING
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.


Instructions

Product Instructions

Oak Grigsby 4-way 2-pole Lever Switch Instructions

Installation and wiring diagram for the Oak Grigsby 4-Way 2-pole Lever Switch.

Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
5.0
  • 4.76 average rating from 29 reviews
Sort by
5.0

Make your Tele kick butt !

By

Verified Buyer


I tried this switch for the first time on a couple Telecasters. I find the quality of this switch is excellent. The four positions work great! The extra series wound position is great for solo work.
It increases the output signal so that you don't have to use a boost. Great for single coil Teles.
I would not use this switch on a guitar that has humbuckers installed. I'm sure that I will be using this switch on all my custom Teles for now on . I like this Switch !!
JW Guitars

5.0

Great...

By

Verified Buyer



My second homemade guitar.

5.0

Great Upgrade for my Telecaster

By

Verified Buyer


The variation on sound from the different pickups made this an excellent upgrade. Wiring schismatics were included with the switch. Installed with a SH pickup set up on a Telecaster. Great investment, great upgrade.

5.0

great upgrade

By

Verified Buyer


I put this switch in an '89 MIJ left handed telly. It is an easy install for anyone who has a little experience in guitar mods. I did not have to widen or lengthen switch plate slot but did have to drill out the switch screw holes. The schematic does not show standard telly caps or wiring, I ignored the wiring that did not effect the switch and it worked fine. The new ground from the neck pickup cover does have to be done for this to work. I'll be playing this one more now, strats a little less.

5.0

A Must for a Tele build.

By

Verified Buyer


I build a lot of Classic and Modern Teles and this is a very inexpensive and easy install to expand the tones of your build.

5.0

Very positive feel

By

Verified Buyer


better than the 'original' switches they are replacing

5.0

good

By

Verified Buyer


good

5.0

Top Quality Switch

By

Verified Buyer


Worth every penny. I've used this switch on 3 guitars so far with fantastic results. Love the 4th position for series option or can be used for something else.

5.0

Great switch may need to widen plate slot

By

Verified Buyer


Nice quality switch and switching positions feels great. I previously had a cheap knob that did not fit as tight as the ones provided here.

NOTE: I had to use a Dremel and widen the control plate slot by a few mm. If you can't get position 1 to work it's not a faulty switch. The 4-way travel is slightly greater than a CRL 3-way. You can also file down the blade itself.

In the photo you can see the switch under the widened slot which allows the blade to travel further

5.0

Great  product and fast service

By

Verified Buyer


These switched fill the bill.

Showing 10 of 29 Read more reviews >>
 
  • Telecaster®, Tele®, and Esquire® are registered trademarks of Fender Musical Instruments Corporation.