Go-bar Clamping Deck
Assembly instructions for the Go-bar Clamping Deck.
I-4733
| Hardware Kit #4733 parts list (4) Threaded rod 1/2" x 36" (4) Propeller T-nut, 1/2" (4) 1" Support tube, 29-1/2" (8) Aluminum end washer (4) Flat washer, 1/2" (4) Hex nut, 1/2" You will also need (6) Laminated plywood 2' x 2' x 3/4" Concave wooden dish for front and back Titebond wood glue |
 |
 |
Go-bar deck assembly
From a sheet of 3/4" plywood, cut six pieces, each 2 feet x 2 feet. Stack and glue two of the pieces together, and stack and glue the other four together (the extra thickness is required to give the go-bar deck base sufficient stiffness).
Drill a 1/2"-diameter hole in each corner, 1" from each edge. Assemble the parts from the hardware kit as shown in the "exploded" diagram below.
Use wooden blocks (or any solid, well-supported platform) to raise our concave wooden soundboard dish, or our concave back dish, to the desired height above the base of the deck. Our flexible 24" fiberglass go-bars should be used for clamping, as shown above.
