Mighty Mite Vintage Amber Neck for Tele

Mighty Mite Vintage Amber Neck for Tele, Indian Rosewood fingerboard
Indian Rosewood fingerboard Item # 5717-VT In stock, ready to ship!
$171.76
Mighty Mite Vintage Amber Neck for Tele, Maple fingerboard
Maple fingerboard Item # 5718-VT In stock, ready to ship!
$171.76
Mighty Mite Vintage Amber Neck for Tele, Indian Laurel fingerboard
Indian Laurel fingerboard Item # 5747-VT In stock, ready to ship!
$171.76
Original:
$
Save:
$
Total:
$
Qty:
Please enter a quantity

Mighty Mite Vintage Amber Neck for Tele

Shaped, inlaid, fretted and finished—Hard rock Maple with a thin, vintage tint finish. These necks look and play great!

Choose solid Maple, Indian Rosewood, or Indian Laurel fingerboard. All have a single-action truss rod and traditional "skunk stripe" down the back. The string nut is slotted and shaped from PPS plastic with a flat bottom.

  • Thin polyurethane finish
  • 22 frets
  • Maple, Indian Rosewood, or Indian Laurel fingerboard
  • Peghead-adjustable truss rod (for 4mm Allen wrench)
  • Traditional dot inlays
  • 10mm diameter pegholes
  • Without mounting holes, so you can drill to fit your body

Peghead is drilled for 6-in-line tuning machines. 10mm-diameter holes fit sealed gear tuners with threaded peghead bushing. See all tuners.

Specifications
 
Scale length 25-1/2" (647.70mm)
 
Width at nut 1-5/8" (41.28mm)
 
Width at 22nd fret 2-3/16" (55.56mm)
 
Fretwire .045" high x .095" wide (1.14mm x 2.41mm)
 
Approximate heel length 3-5/8" (92.07mm)
 
Fretboard radius 9-1/2" (241.30mm)
 
String post spread 4-11/16" (119.06mm)
 


The skunk stripe is the same wood as the fingerboard for necks with Indian Rosewood and Indian Laurel fingerboards. Necks with maple fingerboards have merbau wood skunk stripes.

Neck thickness (approximate; not including fret)


Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.

These necks are made for us by Mighty Mite®, and have peghead shapes licensed by Fender®.
Telecaster®, Tele®, and Esquire® are registered trademarks of Fender Musical Instruments Corporation.
California Proposition 65 Warning
Cancer and Reproductive Harm