Bridge Pin Hole Reamer
3-degree angle
Item # 3227
Email when available
We'll email you when this item is available for purchase.
Email sent
Your request has been sent! We'll notify you when this item is available for purchase.
$142.49
5-degree angle
Item # 3229
In stock, ready to ship!
$142.49
Set of 2
Item # 3230
Email when available
We'll email you when this item is available for purchase.
Email sent
Your request has been sent! We'll notify you when this item is available for purchase.
10% OFF!
$256.48
Bridge Pin Hole Reamer
Accurate holes for a better fit! Our special wooden-handled steel reamers properly taper the holes for bridge pins.
These reamers are semi-fluted, to help keep the holes round, and are available in two sizes.The 3-degree reamer tapers from approximately .312" to .150", with 3" cutting length, and is suitable for many bridge pins from Gibson and Gurian.
The 5-degree reamer tapers from approximately .312" to .135", with 2" cutting length. It works for our vintage-style pins, as well as modern Martin bridge pins.