Please see our COVID-19 Statement
Mighty Mite Neck for Tele Guitar

Mighty Mite Neck for Tele Guitar

Mighty Mite Neck for Tele Guitar Indian Rosewood fingerboard

Indian Rosewood fingerboard

Item # 5718
Due 1-2 weeks
Email when in stock

$134.29

Mighty Mite Neck for Tele Guitar Maple fingerboard

Maple fingerboard

Item # 5719
In stock, ready to ship!

$133.22

+
Mighty Mite Neck for Tele Guitar Indian Laurel fingerboard

Indian Laurel fingerboard

Item # 5712
In stock, ready to ship!

$134.29

+
 
Total:
Qty:
Scroll to Top

Mighty Mite Neck for Tele Guitar

About This Item

Shaped, inlaid, fretted and finished—feels and plays great! Hard rock maple finished in clear satin polyurethane, with an inlaid "skunk stripe" down the back.

The frets are nicely finished, and the slotted nut is shaped from PPS plastic with a flat bottom. Maple, Indian Rosewood, or Indian Laurel fretboard with dot inlays and side markers.

Indian Laurel (Terminalia elliptica) is a great alternative to rosewood that can be shipped worldwide. It has a similar dark brown appearance to Indian Rosewood, with a slightly more porous texture and occasional light colored grain lines.

Screwholes for attaching to the body are not drilled. Each neck has a single-action truss rod with a 4mm adjusting nut at the peghead. We recommend Allen Truss Rod Wrench for adjusting neck relief.

Peghead is drilled for 6-in-line tuning machines. 10mm-diameter holes fit sealed gear tuners with threaded peghead bushing. See all tuners.

More specifications:
Scale length 25-1/2" (647.70mm)
Width at nut 1-5/8" (41.28mm)
Width at 21st fret 2-3/16" (55.56mm)
Fretboard radius 9-1/2" (241.30mm)
Fretwire .045" high x .095" wide (1.14mm x 2.41mm)
Fret count 21
Approximate heel length 3-5/8" (92.07mm)
String post spread 4-11/16" (119.06mm)

Neck thickness (approximate; not including fret)


Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.

The skunk stripe is the same wood as the fingerboard for necks with Indian Rosewood and Indian Laurel fingerboards. Necks with maple fingerboards have merbau wood skunk stripes.



CALIFORNIA PROPOSITION 65 WARNING
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.


Trade Secrets!

Trade Secrets!

Fine tuning a bolt-on replacement neck

Erick Coleman pulls his old Strat out of mothballs and gives it a new neck. He shows what's needed to get a replacement neck ready to play.

Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
4.5
  • 4.46 average rating from 78 reviews
Sort by
Displaying 1 of 8
1 2 3 4 5 6 7 8
5.0

Beautiful Telecaster neck

By

Verified Buyer


I am very happy with the maple telecaster neck. This one looked as if it was slightly tinted and had much better fretwork than the two other strat necks I bought in the same transaction. The tele neck was nearly as good as my brand new MIJ Hybrid telecaster. These are Indonesia made necks are very nice and I can happily recommend them.

5.0

great neck

By

Verified Buyer


bought this neck to replace a crappy neck on a mim fender tele. fantastic neck but the high e was to close to the fret end but the customer wanted a bone nut so it didn't matter.string groves were spot on 2nd thru 6th but spacing was almost an 1/8th inch wider between 1st and 2nd.

5.0

Awesome neck!

By

Verified Buyer


I bought this neck to replace a cheap neck that had a slew of problems. All I had to do was polish the frets and this Mighty Mite made my guitar play better than it ever had. Neck was straight, frets were levelled perfectly and allowed for a super low action with zero buzz. Very happy I got it. I was about ready to give up on my tele parts caster but now it's my favourite guitar.

5.0

Beautiful neck

By

Verified Buyer


Fell in love with the feel of this neck. No sharp frets, fretboard is gorgeous, no finish flaws either. Beautiful

3.0

Not Bad, Could Be Better

By

Verified Buyer


Bought this to replace a maple fretboard neck on a Highway One. Fit was nice and tight and neck radius is good for an older guy with wonky hands.
My main issue is the placement of the nut. It seems that it's somewhat closer to the edge on the high side and has quite a bit of room on the bass side. When I'm playing, the high E will sometimes slip off the neck. Guess I'll be replacing it sooner than later.

5.0

great

By

Verified Buyer


top quality as usual .

3.0

Looks Great. Fits Fine. Fret ends need to be filed down.

By

Verified Buyer


Looks Great. Fits Fine. Fret ends need to be filed down.

4.0

Quality neck for the money

By

Verified Buyer


I bought this for an Esquire build. Really nice and thin neck. Just make sure you buy conversion bushings for your tuning machines.

4.0

Not bad...

By

Verified Buyer


Stew Mac: Was pleased with the returns process and ease to do so. Thank you!

Mighty Mite Neck(s):
Originally had to send back the initial neck which had issues with the workmanship of the nut, excessive fret end sprout, and was a one piece neck instead of two (maple). Stew Mac had exchanged it for a new neck (Rosewood) and honored the original sale price at the time of purchase.
The replacement neck was exactly what I needed. This was to replace an out-of-tune E-Series Korean Squire Tele neck from the 90's. I was not interested in trying nut-compensation.
the new neck thankfully fit perfectly in the neck pocket. It only needed to be touched up for light fret-end sprout and to have the frets polished. Added the Fender 2-pin staggered locking tuners to complete the project.

For the price, I think the neck is, for the most part, worth it and would recommend it to others.
You'll most likely need to tweak the finer details to your liking.

5.0

Mighty Mite Tele Neck

By

Verified Buyer


Mighty Mite was recommended by a friend ,who works at Buzzo Music, and I am very happy with the Tele neck I purchased !
It feels great and looks great.

Displaying 1 of 8
1 2 3 4 5 6 7 8
 
  • These necks are made for us by Mighty Mite®, and have peghead shapes licensed by Fender®.
  • Telecaster®, Tele®, and Esquire® are registered trademarks of Fender Musical Instruments Corporation.