Please see our COVID-19 Statement
Shielded Push-back Wire - 16 inches

Shielded Push-back Wire - 16 inches

Shielded Push-back Wire - 16 inches

Item # 5950
In stock, ready to ship!

$1.47

+
 
Total:
Qty:
Scroll to Top

Shielded Push-back Wire - 16 inches

About This Item

Here's the right wire for Gibson and vintage-style guitar circuitry. The cloth insulation simply pushes back to expose the center conductor wire.

The 22 AWG single conductor shielded wire has a tinned stranded conductor, white celanese and black waxed cotton insulation, and a tinned braided copper shield. Sold pre-cut into 16" lenghts. Also available in 50-foot rolls.

Diameter: 0.090" (2.29mm)
Length: 16" (406mm)

Save over 20% when you buy 50-foot rolls of Shielded Push-back Wire.


CALIFORNIA PROPOSITION 65 WARNING
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.


Instructions

Product Instructions

Humbucker Pickup Kit

Assembly instructions for the humbucker pickup kit.

Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
5.0
  • 4.71 average rating from 48 reviews
Sort by
4.0

Branded wire

By

Verified Buyer


Wire works great. A little difficult to strip back. Use a needle or safety pin for the braid. I cut through the wire several times when stripping the cloth insulation.

5.0

great for guitar wiring harness

By

Verified Buyer


I used this to create a new wiring harness for a hollowbody archtop electic. Worked great, would use it again.

5.0

PAF type braided wire

By

Verified Buyer


This is my favorite wire for standard humbuckers I make for guitars
I build in the shop. Never need to strip insulation and looks good too!

5.0

Looks Great, Works Great

By

Verified Buyer


Did the job for upgrading cheap wire in a cheap guitar.

5.0

Good stuff

By

Verified Buyer


Good stuff. Hasn't let me down yet.

5.0

Just a bit Longer

By

Verified Buyer


This is not a complaint review. I am exceedingly happy with the product. This is an observational review. I just rewired my 2014 Gibson Les Paul. My Les Paul has the factory long switch. The 16" length is 'JUST' long enough to make it from my switch to my input jack with absolutely NO slack at all. If I had a short switch it would have given me just a little more to work with. The job would have been easier if there had been one more inch of length to the wire. It works, but the wire is not relaxed in the control cavity. I will be posting a pic tomorrow. So my request is to offer this wire in 17" lengths as an option. Other than that, this product is excellent. Thanks for offering this.

5.0

Didn't think I'd have much to say... it's wire

By

Verified Buyer


This stuff is much better than other variants I have used. Heavier gauge and accurate to vintage instruments. Other companies wire offerings seem small compared to what I've seen in vintage instruments. I will be buying more in the future.

5.0

old school

By

Verified Buyer


great wire for that vintage look

5.0

Good wire

By

Verified Buyer


I bought four to redo the electronics on an older Epi Les Paul Custom. They won't make it from the switch to the input jack but long enough for everything else. Wired it up with CTS pots and '57 Classics, looks like it came from the Gibson factory! Sounds good too.

5.0

Best $1.25 I ever spent!

By

Verified Buyer


Stew Mac. is always there. A few inches of good wire and the hum went away. Thank you.

Showing 10 of 48 Read more reviews >>