Shielded 4-conductor hookup wire. Used to gain tonal flexibility, allow coil cuts, combine the coils in series or parallel, or wire the coils in or out-of-phase.
Reduce unwanted electrical noise by using shielded wire for your longer wiring runs (for example, the connection between the controls and the output jack). This shielded wire contains inner copper conductors covered with polyethylene insulation, which is surrounded by an outer conductive shield, which is connected to ground. The black outer jacket material is PVC.
Also available in 25-foot lengths.
Tinned copper conductor
Foil shield with tinned copper ground wire
0.120" (3.05mm) outer diameter
16" (406mm) long
Save over 20% when you buy 25-feet of 4-Conductor Circuit Wire.
For short connections between components, use Non-shielded Guitar Circuit Wires or our Vintage Push-Back Wire.
CALIFORNIA PROPOSITION 65 WARNING