Like what you see here?
Subscribe for free! Sign up for Trade Secrets Trade Secrets! Newsletter #promo/14 at Stewart-MacDonald
YIKES! What happened to the knob on this tuner?!
The rest of the tuners on this ’57 Gibson looked worse than this one! Plastic rots, especially plastic tuner knobs from the 50s and 60s. I replaced these knobs, but kept the tuning machines. Read on...
Dan Erlewine, January 24, 2007
We had fun saving this ’57 Junior from decay
This ’57 Les Paul Junior is a beauty. It’s still with its original owner, named Wyn, who was given it on his 17th birthday.(How cool is that?)That’s a picture of Wyn playing it back in the day.
The guitar hadn’t been played for 25 years, and the tuner knobs were shriveled into brittle pieces of brown plastic clinging to the tuning key shafts. What’s more, the finish was so dull and cloudy that I told Wyn, “There’s no way to clean a finish that far gone. This guitar will never play again. I’ll give you $75 for it, and use it for parts.” (Just kidding! A Junior like this is worth a lot of dough nowadays.)
Step 1: off with the old
A few gentle bites from my fret pullers crumbled the rotted plastic and it fell off the shaft easily.
Step 2: clean up the shafts
With the dead plastic removed the spear-shaped button shafts looked like this — green with corrosion.
I used a glue brush dipped in naphtha to wet the crud, making it easier to scrub off most of it with a file cleaning brush.
A wire wheel on a Dremel flex shaft is perfect for getting down to bare metal in seconds.
I use glue brushes for lots of things, often trimming them to a short point. This makes the bristles stiff enough to scrub small nooks and crannies. -Dan
Step 3: on with the new
When the shaft is clean, I heat it with a soldering gun and press on a new tuner knob.
I use a Weller 140/100 watt gun, replacing the tip with two pieces of 3/32” dia. copper wire (the ground from a scrap of heavy-duty electrical wire). With the two wires placed against the tuner shaft, the circuit is complete, and the shaft gets hot fast. It takes 15-20 seconds to heat it enough to install the new knob. The buttons slide onto the heated shaft with ease — wear gloves, though!
Step 4: a drop of glue
As added insurance that the buttons will stay put, I run a drop of #10 super glue into each button. Use a pipette to get a small drop of glue in the right spot.
I thouroughly cleaned the peghead before re-installing the tuners. That took some doing — cleaning this guitar is worth a Trade Secrets issue all by itself!
Problem-solving products mentioned above:
Vintage-style Tuner Knobs Replacement knobs matching those that have deteriorated on many vintage instruments.
Fret Pullers Specially ground mini end-nippers that will cleanly pull frets from the fingerboard and eliminate excessive fingerboard chip-out.
Glue Brush A versatile metal-handled brush that's the right size for routine instrument gluing jobs.
Pipettes Useful in every shop when gluing, finishing, more!
Per bottle
$8.92
Pack of 12
$2.38
Pack of 10
$2.86
To reply to this email, please use this web page: stewmac.com/email
Our customer service representatives are available to serve you
9am-6pm weekdays EST. Call 800-848-2273 today.
You are receiving this e-mail because you have a stewmac.com Trade Secrets subscription.
If you wish to unsubscribe or change your e-mail address, please click here.
