Toggle Switch Knob

Solid piece of plastic. This did not fit my stock Epiphone Les Paul switch, but I planned on replacing the switch anyway.

Stew-Mac only sells one size of this toggle knob. And there are 2 sizes of 3 way toggle. Of course mine is the other one.

As stated before this knob needs work, did not fit my Gibson LP - the hole was too big.

Great

Knob was too loose for the switch post on my new Richmond Empire, so I wrapped plumber's tape around the post threads (as a previous reviewer suggested). Fits and looks great now.

These were too big for the threaded shaft of the selector switch. Just used a thin strip of plumbers tape and bingo, tightened right up.

I bought this for an Epiphone Les Paul, but as the other reviewers said the hole is too big. It fit perfectly on my Gibson Les Paul. I put some Gorilla glue in it, and drilled a smaller hole. Just to be clear, the switch is threaded the knob is not, but the metal thread on the switch cuts a thread in the plastic knob. As with most things made in America the Gibson has an SAE thread #8, I'm guessing the Epi is 3.5mm metric.

Excellent quality, 1 problem: I ordered an LP toggle switch and I needed an SG toggle switch!!

Ordered a toggle knob for my 1972 Sekova Les Paul copy. Apparently they used a lot smaller knobs than Les Paul as I had to sand it down to height and ended up gluing it on as it would not thread on. Works fine with the modifications. Wouldn't be an issue if I had replaced the 3 way toggle, but it was cheaper to replace a missing knob.

I order this tip with a few pickup rings and a jack plate. They don't match the creme color very well, but in low light it shouldn't be noticeable. I also had fit problems, as it's much to large for an Epiphone..