Mini Air Pump

I had hoped for a stronger stream of air. It attaches fine to the StewMac jig for the Dremel tool. It does what it is supposed to do: it removes fine dust. Actually: when you plug it in, you will be surprised that it works, because the stream of air is gentle. But since it is a small cross-sectional area, it actually works.

It was only after ordering this thing that I realized it was only a fish tank air pump.

I should probably have bought one in Australia, instead of buying this, along with a voltage convertor and a plug convertor.

On the plus side, the tube fits my dremel perfectly and this thing does a decent job.

I had problems with saw dust covering up the outlines on the inlay material when cutting inlays. The gentle air stream of this pump pointing directly on the cutting area keeps the lines always visible and speeds up the cutting process enormously.
This pump also works great hooked up to the router base when I route the inlay pockets on the fingerboard.
And it runs quiet enough so it's not getting annoying over time.