3/8" Conversion Tuner Bushing

Ordered these bushings for 10mm holes,they were a little loose but worked. My fault I should have ordered the larger ones. The product very good quality. Thanks,StewMac

I used these conversion bushings to replace the Grover Rotomatics on my Gibson J-45 (2011 standard model) with Waverlys. They dropped right in and the Waverlys work great!

Nice quality parts, as usual. Thanks

My strat standard 96 and my Tele 2003 now sport a vintage look peghead!!
I was expecting a very tight fit but I press them with my fingers and that was it!!Perfect fit, no tools requiered.

These bushings look the same as the original,it's the cleanest way to recover the old school looking without complex adaptations affecting the finishing.

Excellent solution for converting modern to vintage.

I ordered 2 sets just in case. I liked how they fit in my Strat so much that i did the same job to my Tele. They were a perfect fit, a little snug going in but with the proper amount of pressure they fit like they were custom made for both sets of pegholes. Very nicely machined pieces, w no rough edges. They are way better quality than any fender bushings. I highly recommend these for your project.

Actually, the title of this review is a bit over the top (hope my wife doesn't read it!), but these guys certainly do the job and does it right.

These were a perfect fit for the peghead of my '67 Flying V. Allowed me to install double ring Kluson tuners with no additional modifications.

this is a nice product for converting your tele or strat to vintage tuners.