| DEPARTMENTS |
|
| Accessories |
|
| Bindings,
trim |
|
| Bodies,
necks, wood |
|
| Books,
plans |
|
| Bridges,
tailpieces |
|
| Electronics,
pickups |
|
| Finishing
supplies |
|
| Fretting
supplies |
|
| Glues,
adhesives |
|
| Hardware,
parts |
|
| Inlay,
pearl |
|
| Kits |
|
| Knobs |
|
| Nuts,
saddles |
|
| Pickguards |
|
| Tools |
|
| Truss
rods |
|
| Tuners |
|
| Video, DVD |
|
|
|
|
1/4" Hex Nut Hot Rod
Standard 1/4" hex nut design for electric guitars and banjos. Hot Rod® Truss Rod's smooth two-way action steel rods correct upbow and backbow, resulting in complete control over the neck.
See details below
|
|
|
Easy to install. The Hot Rod® fits in a straight channel. For proper operation, this truss rod must be installed so that the active rod (the rod with the adjustment nut) is below the passive rod. A wooden filler stick is not required.
Our Hot Rod neck adjustment system features twin rods in threaded brass collars. The stainless steel active rod turns for smooth neck alignment, with 2-way action. The Hot Rod requires an access cavity for the adjustment nut, and a straight 7/32"-wide x 7/16"-deep slot (measured from the bottom of the fretboard) for installation. The 18" rod fits many electric guitars and banjos.
We've designed the Router Bit for Hot Rod Truss Rods especially for routing your neck to fit our truss rods.
Hot Rod® is a registered trademark of Stewart-MacDonald Manufacturing Company, Inc.
Shown on page 69 of our latest catalog.
|
|
|
|
Details
Pictures
