Binding Router Bit

I used the bit with bearing guide on my router table and was able to route both sides of my Tele body for a binding in less than ten minutes. Clean, precise and super-easy. Take you time setting and testing the height and the rest is easy.

You need one of these. In a proper router set up, they are great. The bits can be cleaned in acetone to remove wood resins and cleaned after each routing job

Not that I really do much binding compared to the amount of guitars I build without binding, but its no different than the other bits, well made and stay sharp for a pretty long time. No better or worse than any other quality router bit. They all get dull eventually and then you have to get another one...

This router bit is one of the nicest you can buy anywhere. It is extremely sharp and well made (be careful removing the covering from it!). It cuts a very clean channel and does so in one pass when paired with a good router and steady hand.

The binding router bit worked well with my Bosch router and the bearings. I was able to rout the binding ledge in one pass.

Great tool!

This bit and the various bearings are of good quality and are pretty long lasting with a good clean cut.

Great tool! Once you have developed the feel to run it around the edge of the guitar, it is a breeze. I like the accuracy and consistency of the cut. Make sure you use a strong enough router.

The router bit is an excellent partner with the Bosch Colt router. It is expensive, but cutting into an assembled top, back and sides with much time and money invested is no time to work with a cheap cutter. Some fuzz will be left on spruce tops. I ignore and sand off when sanding/scraping the purfling flush.

Works really well and cuts a neat channel.