Ball Bearing Router Bits

these do the job well.

The idea of ballbearing routers and templates is genius, but as an amateur doing his first routing job,I broke all bearings and some templates. Don´t know if I will do it again

Excellent cut, better than those found in the market

These bits are great. I've used them on two different builds so far, two different body woods, a hard wood and a soft wood, cuts both like butter. Couldn't be happier.

This is the first time I've had ball bearing guides and a template. The template squared up easily and the bearings followed it like cake. I had to route the out-side of the guitar to due to it shape, otherwise sanding was quite difficult. I wish I had also ordered the 3/8" bit with the shorter cut instead of the one I got at a hardware store.

Was a little weary of the teflon spacer but it worked flawless as designed, needed for the small bearing I reconditioned. Used it for corners on a humbucker cavity, useful to say the least.

My first guitar and pickup cavity cut. My cheap router had no problem cutting through the maple. It worked perfectly with the humbucker template from StewMac. See for yourself :)

These bits along with the Stew Mac templates I now have much cleaner cavity and pickup routing.

It's my fourth set in the last 10 years and it always gives an excellent result.
Thanks

I'm an amateur in the Luthier community, but this item was just what I needed. Very accurate routing was produced as far as I could notice. It's a must have, if you want to do the job right. A+++