Neck Joint Routing Template For Fender

way, way too oversized don't buy it until they have the right size

The majority of the negative reviews I've read on this site downplay the worth of this template because it is not cut to the exact size of their neck, but is cut 40/1000ths of an inch too large. If those same people would simply follow the instructions by applying binding tape to the inside of the template till it fits their individual neck exactly, they'd find that it is not just an incredibly accurate tool, but a versatile one as well. Needless to say, I am very impressed with this product.

I knew I was taking a chance, but the template is too narrow for the Squire neck I am using in a current build. Would be nice if there was an option for templates sized for use with a router bushing.

This template really makes it easy. The long centerline lets you line it up, and the sizing is spot-on.

I used this template to build my first guitar. As I already had significant experience with other types of woodworking, it was easy to use with my router and 1/2" bearing bit.

The description was accurate, as the template was noticeably larger than the neck I used. However, as indicated in the video, it only required some patience and a few layers of tape to get a good fit. In my case, it was five full layers of duct tape around the inner edge, plus an additional two layers of duct tape in the corners only. I might have used a third layer of tape in the corners, as there is a gap just big enough for a single sheet of paper in the corner of my body, but otherwise, the final fit is perfectly snug and looks great.

I have no complaints about the template. Like others have said, it might have been nice to have it give a tighter fit, but this way you have plenty of room to work on.

The key with this item is controlling the depth. It would be nice if it was a little thicker but then I'm sure the cost would be too much. Added another bearing on my router bit and used the template with some extra mdf to make it work. Once you have the right depth it works like a charm. Definitely glad I bought it.

i have the full set and i use them to make thicker templates and keep these as masters.

i ordered the template cause i wanted an acurate one, but man is this thing oversized or what? Forget about the tape, done it and still doesnt work right. Its funny cause i had done one my self by tracing the strat neck that i have, and still ordered this one thinking it would be better. Very dissapointing.

I'm getting one of these, but understanding there is a width variance, I will most likely minimize the variance using copper shielding tape (not binding tape which I feel has a gummier adhesive) then transfer the template to MDF thus creating a new and more accurate template.

I'd love to see Stew-Mac offer three templates, this one, one a tad smaller for a tighter fit, and a third that's angled slightly for angled neck pockets. Sell them as a three-fer.

The template itself is accurate but too thin which means you need to use spacers and then reset the template a second time which is a hassle and causes a margin for error. I save this as the Master and use it to make a 1/2" MDF Template so I dont have to use spacers. The worst thing I've found with plastic templates is that if a bearing decides to freeze up then it quickly melts the template side wall. Keep your plastic templates as "Masters" and use MDF. Just my opinion.