Flush-cut Saw

I had to replace a non-standard sized bridge and stop tailpiece on an ebay special. This saw worked perfect for trimming the excess wood on the plugs I used. Could not have done the repair job without the saw.

I defretted my bass guitar and used maple veneer to fill the slots. After gluing them in place, I used the saw to cut off the excess veneer strips at the radius of the fretboard. It worked perfect and I didn't gouge the fretboard like I was afraid I would do.

This saw is a great size, small and compact, easy to use, cuts cleanly. I use it all the time on small work.

Works just as it should. Very sharp but wont mark faces while cutting off a dowel for example.

I bought it because I needed a couple of times in the past. The cost is very affordable and you will use it several times. Highly recommended