| DEPARTMENTS |
|
| Accessories |
|
| Bindings,
trim |
|
| Bodies,
necks, wood |
|
| Books,
plans |
|
| Bridges,
tailpieces |
|
| Electronics,
pickups |
|
| Finishing
supplies |
|
| Fretting
supplies |
|
| Glues,
adhesives |
|
| Hardware,
parts |
|
| Inlay,
pearl |
|
| Kits |
|
| Knobs |
|
| Nuts,
saddles |
|
| Pickguards |
|
| Tools |
|
| Truss
rods |
|
| Tuners |
|
| Video, DVD |
|
|
|
|
Be ready for any tuner installation
Peghead Bushing Reamers
Before you install press-fit tuner bushings, be sure they'll fit correctly, so your tuners will work efficiently. Too tight, and they can chip the peghead finish or crack the wood. Too loose, and they can rattle or fall out. Our custom reamers cut a clean, accurate counterbore for a professional job.
If you have a repair shop, you'll want the complete set on hand. Be ready for any tuning machine installation!
See details below
|
|
|
| Item# |
Description |
In stock |
Price |
Quantity |
|
 |
|
|
|
|
|
|
|
Designed for slow-speed use in your drill press, each steel reamer is 2-3/4" (69.85mm) overall length, with a 1/4"-diameter (6.35mm) pilot and two 1" (25.40mm) cutting flutes. The set of five includes sizes for popular guitar and mandolin press-fit tuner bushings.
Important: Please measure your tuner bushings before your order a reamer. Measurements are also available by clicking on the Specs tab at our tuner webpages.
NEW! Don't use a hammer! Our Tuner Bushing Press installs and removes press-fit peghead bushings cleanly.
Shown on page 27 of our latest catalog.
|
|
|
|
Details
Pictures
