Carbide Downcut Inlay Router Bits

These are great bits, and you can't do any good inlay work without them.

I love the bit I bought so much I plan on getting more sizes. Great!

What beautiful, sharp little guys these are! The cleanest inlay routing I have ever done.

Purchased the 3/32 and the 3/64 to route inlay pockets for a LP standard rosewood fret board. Couldn't be more pleased. Did a test route with the 3/32 but it was obvious that it would be a little to large for the margins and corners and way to aggressive that close up so I opted too use the 3/64 for everything. That little guy cut through that rosewood like the proverbial hot knife in butter. Also used it to undo two MOP inlays fully set up and while I needed to take this a little slower it did the job well. Absolutely no fuzzy edges just as advertised. While $18 is a little rich for something the size of pencil lead I couldn't find it cheaper elsewhere so what's a guy gonna do.

I couldn't have done my first rosette without them.

Now I can do nice and clean inlay routing with these bits

Its great but it can be found in te market for less money...

These bits perform exactly as advertised. A very clean cut and impressive for routing inlays on fingerboards.

These router bit a simply perfect! They are not cheap, but defenitly worth the money. I couldn´t do without them.

I purchased the set not knowing what to expect. The bits are high quality, and amazingly clean-cutting for small inlay bits. I use one of the smaller bits way more than the others and have been impressed with how long it has stayed sharp for the amount of cutting I have done. Normal care for tiny tools is required. You will not be disappointed!