Fret Polishing Wheels

Coupled with a Foredom tool and a little experience this system is blazing fast! The most important thing is to take one quick light stroke with a wheel that's been grooved with a round file. A little goes a long way!

These work well as stated but are tricky to use as you must first groove the discs properly

it's a real challenge to sit them at 90 degrees to the fret you are trying to polish
even if you're using the flexible shaft on the Dremel
so you want to make the groove in the wheel ideally off centre so you can angle the Dremel a bit.

Wheel can slip off fret suddenly if you're not careful and cause marks on fretboard

Use with care!

Indeed, they'll make 'em shine but Micro Mesh over a medium density foam pad is WAY FASTER with no worries about running off the fret and "engraving" the fret board.

I used these polishing wheels on an ES-335 and they work great. I chucked them directly into my old dremel tool and had no trouble getting a quick mirror finish on the frets. What a great timesaver. I would recommend these to anyone.

Almost every guitar I get in for a set up or repair has dull or corroded frets. These polishing wheels work great to get them nice and shiney again.

Good product, especially the fine wheels. The extra fine wheels are a little too fine though, you get a better (and easier) final polish with a felt wheel and a bit of polishing compound.
I've read that you can put a groove in these wheels with a file handle but i found i just ended up with a shiny file handle. Folding a bit of 320 grit sandpaper to a nice round fret shape and shaping the wheel on that works a lot better.

These are great, the shine you get is brilliant but make sure you don't have the Dremel to fast as they get very hot. Be careful with the file to put the groove in, they will polish the teeth off. If they came with a groove already in they would achieve excellent rating.

Practice on something besides your customer's guitar first. These really heat up the frets, and they tend to bounce so use some kind of fretboard guard. Once you get the hang of it, they work like a charm. They will polish frets to almost a glass like surface.

Combined with the fretboard protectors, these wheels are awesome. For non-maple boards, my prior method was to use super fine steel wool to remove the gunk and clean up everything. Now I use the Ernie Ball fret board wipes and the Stewart-MacDonald fretboard protectors with the extra fine wheels in a low speed battery dremel tool to give the frets a quick touch up when needed at string change time. I have not had to resort to the fine wheels yet but bought the full kit because I know that if I went individually I would have needed the one I didn't buy the next time. Good value and works well.

Fastest smoothest fret polishing I have ever used. I allready had the dremel with the extention snake thang. Be sure to tape the neck first.