| DEPARTMENTS |
|
| Accessories |
|
| Bindings,
trim |
|
| Bodies,
necks, wood |
|
| Books,
plans |
|
| Bridges,
tailpieces |
|
| Electronics,
pickups |
|
| Finishing
supplies |
|
| Fretting
supplies |
|
| Glues,
adhesives |
|
| Hardware,
parts |
|
| Inlay,
pearl |
|
| Kits |
|
| Knobs |
|
| Nuts,
saddles |
|
| Pickguards |
|
| Tools |
|
| Truss
rods |
|
| Tuners |
|
| Video, DVD |
|
|
|
|
Audio-taper potentiometers
Blend Pots
Our unique audio-taper pots controls the signal mix from two pickups or sources, panning from one source to another, with both signals full at the center detent. The M7 x 0.75 threaded portion is 3/8" tall. Flat washer and two mounting nuts included; 9/32"-diameter mounting hole required. Split shaft with coarse knurling.
See details below
|
|
|
250K vs. 500K
Generally, 500K-ohm pots are used with humbuckers and 250Ks are used with single-coil pickups. You can use any value you like, but a 250K will give a slightly warmer tone than a 500K pot. The 250K pot bleeds off (attenuates) some of the high frequencies to ground.
To see the knobs available for these pots, click here.
Shown on page 51 of our latest catalog.
|
|
|
|
Details
Pictures
