| DEPARTMENTS |
|
| Accessories |
|
| Bindings,
trim |
|
| Bodies,
necks, wood |
|
| Books,
plans |
|
| Bridges,
tailpieces |
|
| Electronics,
pickups |
|
| Finishing
supplies |
|
| Fretting
supplies |
|
| Glues,
adhesives |
|
| Hardware,
parts |
|
| Inlay,
pearl |
|
| Kits |
|
| Knobs |
|
| Nuts,
saddles |
|
| Pickguards |
|
| Tools |
|
| Truss
rods |
|
| Tuners |
|
| Video, DVD |
|
|
|
|
Audio-taper potentiometers
Push/Pull Pots
These dual-function pots can be used as a normal volume or tone control, and they also pull up to activate an on/on double-pole double-throw mini switch. They can control pickup phasing, series/parallel switching, coil-taps, and more.
See details below
|
|
|
|
|
|
|
|
|
|
#3755 25K-ohm
A volume or tone control for active pickups, or for use after the preamp of a piezo-saddle electric guitar bridge such as the Baggs T-Bridge. Split shaft has coarse knurling. Two mounting nuts, flat washer and lock washer included.
Thread | M7 x 0.75 | Threaded portion height | 3/8" (9.52mm) | Required mounting hole diameter | 9/32" (7.14mm) | Required body cavity depth | 1-1/8" (28.58mm) |
#1215 250K-ohm
Split shaft has coarse knurling. Two mounting nuts, flat washer and lock washer included.
Thread | M7 x 0.75 | Threaded portion height | 3/8" (9.52mm) | Required mounting hole diameter | 9/32" (7.14mm) | Required body cavity depth | 1-1/8" (28.58mm) |
#1216 500K-ohm
Split shaft has coarse knurling. Two mounting nuts, flat washer and lock washer included.
Thread | M7 x 0.75 | Threaded portion height | 3/8" (9.52mm) | Required mounting hole diameter | 9/32" (7.14mm) | Required body cavity depth | 1-1/8" (28.58mm) |
#1213 500K-ohm,long shaft pot for Les Paul
Split shaft has coarse knurling. Two mounting nuts, flat washer and lock washer included.
Thread | 3/8 x 32 | Threaded portion height | 3/4" (19.05mm) | Required mounting hole diameter | 3/8" (9.52mm) | Required body cavity depth | 1-1/8" (28.58mm) |
250K vs. 500K
Generally, 500K-ohm pots are used with humbuckers and 250Ks are used with single-coil pickups. 25K pots are used for active systems.
You can use any value you like, but a 250K will give a slightly warmer tone than a 500K pot. The 250K pot bleeds off (attenuates) some of the high frequencies to ground. A 1 Meg-ohm pot will attenuate even less than a 500K pot, so if you want to hear your guitar "wide open" you may want to try one.
We also have a full line of control pots for non-active circuitry. Extra mounting nuts and lock washers are also available.
To see the knobs available for these pots, click here.
Shown on page 51 of our latest catalog.
|
|
|
|
Details
Pictures
