Everything for building and repairing stringed instruments!

Your order | Account | Saved list

Home

Free catalog

Quick order

International

Customer service

Home : Electronics, pickups : Pickups: Guitar, archtop : Kent Armstrong Suspended Jazz Humbuckers


Tell me more

DEPARTMENTS

Accessories

Bindings, trim

Bodies, necks, wood

Books, plans

Bridges, tailpieces

Electronics, pickups

Finishing supplies

Fretting supplies

Glues, adhesives

Hardware, parts

Inlay, pearl

Kits

Knobs

Nuts, saddles

Pickguards

Tools

Truss rods

Tuners

Video, DVD

MORE FROM STEWMAC

Shop by instrument

Free information

Gift certificates

New items

Web exclusives

E-mail newsletter

For archtop guitar, no routing needed.

Kent Armstrong Suspended Jazz Humbucker

A mellow mini humbucker for archtop jazz guitar. No routing is needed — the brackets attach to the end of the fingerboard, suspending the pickup above the guitar top in the Johnny Smith style. The blade polepieces and coils are epoxy-sealed for feedback suppression, with exposed solder lugs.

See details below

Electronics,_pickups : Pickups: Guitar, archtop : Kent Armstrong Suspended Jazz Humbucker : A mellow mini humbucker for archtop jazz guitar.

Item#

Description

In stock

Price

Quantity

5068

Chrome
Non-RoHS compliant, cannot ship to EU countries

Yes

$63.67
3 or more $53.94

5068-G

Gold
Non-RoHS compliant, cannot ship to EU countries

Yes

$73.87
3 or more $63.77

Quantity prices apply to multiples of the same item number

Selected currency

Details

Pictures

Mounting a Kent Armstrong Suspended Jazz Pickup

Installation instructions

i-5068 Updated 03/03

The #5068 Suspended Jazz Pickup is intended for mounting to the end of a guitar's fingerboard. The two mounting tabs wrap around the outside of the fingerboard and the pickup is attached with the four supplied screws. Once you have the tabs properly profiled to fit the neck, mark the four mounting tab holes on the edges of the neck and drill 1/16" pilot holes for the screws.

The tabs can be bent with pliers to match your fingerboard's width and profile. Wrap the jaws of the pliers with electrical tape to protect the pickup. You may also find it necessary to "tweak" the angle of the mounting tabs relative to the face of the pickup. This will insure that the pickup is parallel to the stings. When bending the tabs, grasp them near the pickup housing and gently bend them the desired amount. Try to avoid re-bending.

There are two solder lugs on the bottom of the pickup ready for your wiring. We recommend using shielded or coaxial wire to reduce hum and noise. The lug closest to the mounting tabs is the ground or shield lug, and it should be wired to the coaxial wire's outer braid. The inner conductor of the coax will connect to the inner or hot lug.

You can run the pickup straight into an #1521 output endpin jack, or you may choose to use onboard volume and tone controls. These controls can be mounted to the instrument's pickguard, or into holes drilled into the face of the guitar. Diagram #1 and #2 are sample volume and tone pot wirings. Use 500k for brighter tone, 250k for warmer tone.

Shown on page 46 of our latest catalog.

Toll-free order line:

800-848-2273

9am-6pm Eastern Time, M-F

Your order | Your account | Trade Secrets E-mail Newsletter

Home | Free catalog | Catalog Quick Order | International | Customer service

Our guarantee | Shipping | Security & Privacy | Contact us

Site map | About us | Employment