Especially on older pickups. They haelp eliminate that annoying hum.
I found that this product is also great to use as a stop on drill bits. Can be cut to the required length and slid onto small diameter bits, leaving the desired cutting portion exposed. Beats having pieces of tape flapping around and around.
Make sure you grease the inside and both ends to make adjusting your pickups easier and be accurate with your lengths as it doesn't compress like a single coil spring. Is ideal for humbuckers as holds them nice and steady. Cheap too! Also holds your screws in place ready for pickups.
I was in the middle of my strat re-nut and just happened to notice the pickup tubing had that nasty old rubber discoloration. Cheap enough to just "add to the order" and I didn't have any problems with fitment.
This tubing has the exact diameter to get into the springs of my Ibanez edge trem. Works like a charm. In fact this thing has made the springs quieter than a real noiseless springs set that i have,(I think it gives a very little acoustic boost too)
Instead of petroleum jelly, I used bar soap to lube the threads before slipping the tubing over, and that worked well. I used the Tele bridge screws for my Dimarzio Virtual Vintage/Area pickups (they have tall bobbins because of the stacked design). This solved my pickup wobble problems.
The tubing is not too tight, its supposed to be tight, just put a little vaseline on your screw and it'll slide right in. Tubing that is too loose compresses very poorly and you may get pickups that flop around, eh?
Inside diameter too small for both my Stratocaster and Telecaster pickup screws. Completely useless.
The internal diameter of the tubing is a little too snug on the height adjustment screws. This makes it tough to get the tubing over the height adjustment screw, and also makes it difficult to turn the screws, since as the tubing compresses, the screw doesn't rotate freely inside the tubing, and the tubing twists and resists turning due to friction with whatever it is compressing against. This means the size that you cut the tubing too much be precise, otherwise you will have trouble adjusting the height screws.
If the ID were just a little larger, this stuff would be perfect.
To add items to your order, select the check box next to the item you want. You can edit the quantity you wish to purchase here, or in Your Order.
To add items to your saved list, select the check boxes next to the items you want. You can edit the quantity you wish to save here, or in your Saved List.