Shielded Push-back Wire - 16 inches

This is a great way to repair vintage wiring or wire something up from scratch. Looks like something from the 50's and real slick to work with.

It does the job well! Long enough to replace the worn cable of a '78 humbucker end easy to solder to both humbucker and pots.

Wire worked great for an inline splice on a '64 Gibson Pat # Pickup. Works well for most restoration projects,was fantastic for this '64 SG.

This is great wire, but its to short to feed from the switch to the input which turned a perfect job into a not so perfect job it needs to be at least 20in to do all runs unless you want to buy 50ft? That would be great if I was doing 30 guitars! very poor choice of length, not well thought out. Yes I am a newbie, but if it where not for that, everything else was perfect.

Nice wire, easy to work with, and solders well. Just make sure you puff it up a bit and solder on the side of the braided wire where you are going to put the solder so you don't get into the inside wire and cause a problem.

Looks just like the good old stuff and works a treat.

...just keep in mind that no matter the quantity you order, you will get INDIVIDUAL pieces, not a continout length. For my purposes it worked out, but others may need a contious length in excess of 16 inches.

Having a few production lines, I always try to find ways to limit labor costs. Pre-cut pickup wire is a time saver!! These are great for rewinds or replacing pickup wires that have been hacked to short.