The frets are nicely finished, and the nut is shaped and slotted. Maple or rosewood fretboard with dot inlays and side markers.
Screwholes for attaching to the body are not drilled. Each neck has a truss rod with a 4mm adjusting nut at the peghead. We recommend Allen Truss Rod Wrench for adjusting neck relief.
Peghead is drilled for 6-in-line tuning machines. 11mm-diameter holes fit sealed gear tuners with threaded peghead bushing. See all tuners.
Width at nut
Width at 21st fret
.045" high x .095" wide (1.14mm x 2.41mm)
Approximate heel length
Neck thickness (approximate; not including fret)
Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.
Fine tuning a bolt-on replacement neck
In this issue:
Erick Coleman pulls his old Strat out of mothballs and gives it a new neck. He shows what's needed to get a replacement neck ready to play. Read more...