| DEPARTMENTS |
|
| Accessories |
|
| Bindings,
trim |
|
| Bodies,
necks, wood |
|
| Books,
plans |
|
| Bridges,
tailpieces |
|
| Electronics,
pickups |
|
| Finishing
supplies |
|
| Fretting
supplies |
|
| Glues,
adhesives |
|
| Hardware,
parts |
|
| Inlay,
pearl |
|
| Kits |
|
| Knobs |
|
| Nuts,
saddles |
|
| Pickguards |
|
| Tools |
|
| Truss
rods |
|
| Tuners |
|
| Video, DVD |
|
|
|
|
Shaped, inlaid, fretted and finished
Replacement Neck for Tele
This high quality neck feels and plays great! Hard rock maple finished in clear satin polyurethane, with a walnut "skunk stripe" down the back. The 21 frets are nicely finished, and the nut is shaped and slotted. Maple or rosewood fretboard with dot inlays and side markers.
See details below
|
|
|
| Item# |
Description |
In stock |
Price |
Quantity |
|
 |
|
|
|
|
|
|
|
|
|
Screwholes for attaching to the body are not drilled. Each neck has a truss rod with a 4mm adjusting nut at the peghead. We recommend Allen Truss Rod Wrench for adjusting neck relief.
The 10.5mm-diameter pegholes fit 10mm tuners. See all tuners.
| More specifications: |
 |
Scale length |
25-1/2" (647.70mm) |
Width at nut |
1-11/16" (42.86mm) |
Width at 21st fret |
2-3/16" (55.56mm) |
Fretboard radius |
9-1/2" (241.30mm) |
Fretwire |
.045" high x .095" wide (1.14mm x 2.41mm) |
Approximate heel
length |
3-5/8" (92.07mm) |
Neck thickness (approximate; not including fret)
Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.
Telecaster® and Tele® are registered trademarks of Fender Musical Instruments Corporation.
These necks are made for us by Mighty Mite, and have peghead shapes licensed by Fender.
|
Shown on page 70 of our latest catalog.
|
|
|
|
Details
Pictures
