Not much to say about a little dowel of plastic. I would have given it 5 stars but it got 4 cause of the price, which could be lower. Its still cheap but c'mon its a tiny piece of plastic.
Good Stuff !
Very easy to install, both in wood or over plastic (bound necks). Just drill a hole with a bit the same size as the plastic, 1/16" depth or more. Press in the wire and cut with x-acto. No glue needed. May be sanded, scraped, planed and lacquered upon, if needed. Even a beginner can't go wrong. Excellent product.
Installed side dots on a left handed strat set up for righty, looks like a factory job!
A real good product for us leftys to mark a neck on a home-made guitar using a righty neck..
Low cost, no loss, easy to use... all wath I needed!
I am still amazed and relieved that I managed not to desecrate my beloved ancient A1 by installing some side dots myself. The only thing that could have gone wrong would have been drilling the holes out of place. The Stewmac dot stuff was very easy to use and ended up looking like someone who knew what they were doing had done it...
What else to say, good material, nice round section, easy to work with...
I not only use this for side dots but for locating pins for gluing fretboards. Drill a 1/16" hole through the fret slot into the neck blank and pin before gluing. This keeps the fretboard blank from slipping under pressure and you can saw through it easily. My only complaint is they seem a bit pricey for what they are.
Worked like a charm. I started out cutting with flush cut pliers, but it squeezed the material. A knife is the way to go, cut around the diameter carefully like you're cutting pipe. Not a big deal, but just to save yourself a little waste.
To add items to your order, select the check box next to the item you want. You can edit the quantity you wish to purchase here, or in Your Order.
To add items to your saved list, select the check boxes next to the items you want. You can edit the quantity you wish to save here, or in your Saved List.