|
|
 |
Using ColorTone Grain Filler
Application instructions
|
|
|
IN THIS ARTICLE
• Preparation
• Application
• Notes
|
|
 Processing...
ColorTone waterbase grain filler is designed to fill the pores in any open grained woods such as ash, mahogany, rosewood, walnut, and koa.
It will produce a smooth surface that will not shrink after finish is applied.
PREPARATION
|
ColorTone filler comes in a paste form. To prepare it for filling wood scoop about 25% of the filler into a separate container and add 10-15% warm water.
Mix thoroughly until the consistency of the filler is smooth, without any lumps.
|
 |
APPLICATION
|
1. Prepare surface by sanding to 220-grit. Remove all dust, oil and solvents from the surface.
|
|
|
2. Brush on ColorTone grain filler liberally in the direction of the grain, then against it. Allow to dry for up to 10 minutes.
|
|
|
3. Use a grain filler spreader or plastic card to squeegee off excess filler. Wipe at a 45 angle to the grain.
|
|
|
4. When dry, wipe off remaining residue with a clean dry cloth.
|
|
|
5. Sand surface with 320-grit sandpaper. Clean up with warm water.
|
 |
NOTES
- If additional filling is required, allow 30 minutes drying time between fills.
- ColorTone grain filler can be tinted for custom colors using ColorTone liquid stains or waterbase pigments before application.
- Allow drying 2-4 hours before applying waterbase finishes, 24 hours before applying nitrocellulose.
- ColorTone has an unlimited shelf life. If it dries hard in the container simply add a small amount of warm water to reconstitute the filler to the desired consistency.
- Non toxic, no harmful fumes.
- As with all finishing products, use in well ventilated areas. Avoid inhaling residue.
Keep out of the reach of children.
|
|
|
|
ColorTone Waterbase Grain Filler
|
|
|
|
