Stewart-MacDonaldEverything for building and repairing stringed instruments!
Your order cart Your order | Account | Saved list
Sign in
Email
800-848-2273, 9AM-6PM EST, M-F
Home Free catalog Quick order International Customer service

Home : Free Information : Electronics : Switches : Switchcraft 3-way Toggle Switch

Switchcraft 3-way Toggle Switch

Wiring for Les Paul, LP Junior, SG & two-pickup guitars



Email a friend

i-1240 Updated 12/12









 Processing...







The Switchcraft double-pole 3-way switch has been the standard in Gibson® and other 2-pickup American guitars.

Notes on wiring
Reduce unwanted electrical noise by using shielded coaxial cable for your longer wiring runs (for example, the connection between the controls and the output jack). Coaxial cable contains a center “hot” conductor which is shielded by an outer braid used for the ground wire.


For short connections between components, use standard non-shielded wire. Typically, white wire is used for hot, and black for ground to the bridge.


About our kits
Stewart-MacDonald wiring kits contain black and white non-shielded wire, plus shielded coaxial cable. Extra black wire is included for running a ground to the bridge.



#2136 Wiring Kit for Two-Pickup Guitar horizontal line This wiring diagram is suitable for any two-pickup guitar with humbuckers, single-coils, or a combination of both (master volume, master tone).

#2133 Les Paul and #2134 SG Wiring Kits horizontal line

Alternate volume control wiring
You can wire both of the volume controls of a Les Paul (or any other dual volume control instrument) so that you can blend the volume of the pickups independently. This solves the problem at the middle position of the selector switch, in which turning down one volume control affects both pickups.


Switchcraft 3-way Toggle Switch

JPLP Wiring Diagram horizontal line

This Jimmy Page Les Paul wiring option lets you coil-cut the bridge pickup using a push-pull tone control. The other feature of JPLP wiring is that in the middle position of the pickup selector, the bridge pickup is out of phase with the neck pickup.


In this setup, the bridge humbucker cannot be a 2-conductor pickup. The pickup must have 3 or 4-conductor wires, plus a shield or bare wire. Follow your pickup manufacturer’s specs, and wire the series-link (coil-cut) to the push-pull pot as shown in the diagram. Connect the bare wire and the typical “hot” wire to ground (typically the back of the volume pot). Then wire the typical ground wire to the input lug of the bridge pickup volume control. This should give you an out-of-phase sound in the middle position. If not, simply reverse the bridge pickup’s hot and ground wires.









Switchcraft Toggle Switches
Switchcraft Toggle Switches

Premium Wiring Kit for 2-pickups with Toggle Switch
Premium Wiring Kit for 2-pickups with Toggle Switch

Premium Wiring Kit for Gibson SG
Premium Wiring Kit for Gibson® SG®

Premium Wiring Kit for Gibson Les Paul Guitar
Premium Wiring Kit for Gibson® Les Paul® Guitar


Toll-free order line:   800-848-2273   9am-6pm Eastern Time, M-F



Your order | Your account | Trade Secrets E-mail Newsletter
Home | Free catalog | Catalog Quick Order | International | Customer service
Our guarantee | Shipping | Security & Privacy | Contact us
Site map | About Us | Employment
© Copyright 2014 Stewart-MacDonald
Your shopping is secure with VeriSign! Trusted Commerce