Stewart-MacDonaldEverything for building and repairing stringed instruments!
Your order cart Your order | Account | Saved list
Sign in
Email
800-848-2273, 9AM-6PM EST, M-F
Home Free catalog Quick order International Customer service

Home : Free Information : Bridges : Installation : Bridge fitting for archtops

Bridge fitting for archtops

Bridge Fitting Jig for archtops and mandolins



Email a friend

i-5046 Updated 10/08









 Processing...










The Stewart-MacDonald Bridge Fitting Jig is for use with a two-piece "floating" bridge for an archtop guitar or mandolin. It holds the bridge base while the bridge feet are sanded to match the instrument's top curvature.

1. Remove the bridge's top and thumbwheels. Insert the bridge's threaded posts into the slots on the Jig, and reinstall the thumbwheels. Center the bridge base on the Jig, and tighten the thumbwheels to hold the bridge base firmly. Set the assembly on the top of the guitar or mandolin, and adjust the Jig thumbnut to set the angle of the bridge on the instrument's top.

2. Attach medium-grit sandpaper (or the grit of your choice) to the top of the instrument in the area where the bridge will fit. We prefer adhesive-backed paper, but double-stick tape can also hold the sandpaper. Note: Reduce the strength of the adhesive by placing the sticky side against your T-shirt or other cloth apparel. As the tape picks up lint, the tack of the adhesive is reduced. This is essential to avoid removing finish from the top, especially on older instruments.

3. Place two or more strips of masking tape (reduce the tack as described above) on the instrument under the guide wheel, to avoid finish damage. The tape thickness should approximate the thickness of the sandpaper.

4.
Scribble the underside of the bridge feet with a white lead pencil, and use the Jig to sand the bridge feet. When the white markings are nearly removed, use increasingly smaller strokes for a perfect fit.

5. Remove the bridge base from the Jig. Carefully remove the tape and the sandpaper from the instrument, and recheck the fit of the bridge feet. The arch of the bridge feet should now match the radius of the top perfectly.










Archtop Bridge Fitting Jig
Archtop Bridge Fitting Jig


Toll-free order line:   800-848-2273   9am-6pm Eastern Time, M-F



Your order | Your account | Trade Secrets E-mail Newsletter
Home | Free catalog | Catalog Quick Order | International | Customer service
Our guarantee | Shipping | Security & Privacy | Contact us
Site map | About Us | Employment
© Copyright 2014 Stewart-MacDonald
Your shopping is secure with VeriSign! Trusted Commerce