Threaded Endpin Jack

  • 4 Reviews
  • Write a review
Buy more, save more!

Threaded Endpin Jack

Item # 4654
In stock, ready to ship!


3 or more $12.69
Scroll to Top

Threaded Endpin Jack

About This Item

Top quality 1/4" jack can be wired for mono or stereo. Easily tightens from the outside. That's pretty convenient when you can't get your hand in the instrument, especially on ukes!

Tip (positive) is shortest terminal.
Ring (stereo output or battery switch) is mid-length terminal.
Ground is the long terminal coming off the side of the jack.

Overall length: 1-13/16" (46.04mm)
Threaded portion: 1-1/8" (28.58mm)
Thread: 9/16-12
Diameter: .556" (14.12mm)

Installation tip: Use our Tap to cut 9/16-12 wood threads in the tailblock, which will fit the jack perfectly. A 1/2" starter hole is required, get one with our Endpin Jack Reamer.

Installation Key is recommended.

Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
  • 3.75 average rating from 4 reviews
Sort by

Good thing for small instruments

(Customer's Reviews)

I've bought few of those jack plugs for special guitar project, with thinner than common body. Those plugs are easy to install and work fine in my case.


input jacks

(Customer's Reviews)

these work great for giutars that are to thin to mount a plate mounted jack.


well made piece of equip.

(Customer's Reviews)

I have used this endpin jack for several years and recently bought the tap made to cut grooves in the tail block. I have to tighten up the endpin with silicon now to keep tight. this is a very good output jack


end pin error

(Customer's Reviews)

I recently purchased a thread in endpin jack. I got busy and fired up the soldering iron and proceded to get to work. Pickups ready and a new volume pot also just purchased it should have gone really smooth. A short time later I was ready to test out my work. This is not the first guitar project I have done and was pretty confident what the results would be. Into the music studio I go and plug the bad boy in. What.. it doesn't work... What went wrong Check all the connections and every thing is as it should be. A short time later I discovered that the endpin jack was defective. Man all that work and I a get a defective part. A little part hunting in my box of spare parts and I located a jack that I could use in the short term, but now require a replacement from StewMac. Never have I had a problem with defective parts before.

StewMac PDF Catalog, page 46 See Threaded Endpin Jack
on page 46 of our StewMac Catalog PDF

11.5MB File

View with Adobe Acrobat Reader 4.0 or higher.
Download Adobe Acrobat free from Adobe.