Black Plastic Dots

5.0
  • 8 Reviews
  • Write a review
Buy more, save more!

6mm (15/64") dia.

Item # 0016
In stock, ready to ship!

$0.54

25 or more $0.47
100 or more $0.42
+

6.7mm (17/64") dia.

Item # 0012
In stock, ready to ship!

$0.54

25 or more $0.47
100 or more $0.42
+
 
Total:
Qty:
Scroll to Top

Black Plastic Dots

Round black dots for maple or other light-colored fingerboards.

Black plastic dots, .050" thick. #0012 is specially sized for 1970s Fenders.


Customer Reviews

  • EXCELLENT PRODUCT
  • GOOD PRODUCT
  • AVERAGE PRODUCT
  • FAIR PRODUCT
  • POOR PRODUCT
Write a review
5.0
  • 5.00 average rating from 8 reviews
Sort by
5.0

Easy to get great results

By
(Customer's Reviews)


These dots look great and are easy to install. Easiest to do on a bare slotted unfretted installed fingerboard. Just drill a shallow flat-bottomed hole with a 1/4" Forstner bit, put a drop of Crazy Glue in, and press in the dot. Then level it with the wood with a file, not sandpaper, and polish. Even without the glue, the dots are tight, so don't test fit them. The often-seen method of drawing X's between the frets to mark center is not accurate at all, draw a centerline and then mark crosses with a ruler or even just a Mk I eyeball.

5.0

Easy to get great results

By
(Customer's Reviews)


These dots look great and are easy to install. Easiest to do on a bare slotted unfretted installed fingerboard. Just drill a shallow flat-bottomed hole with a 1/4" Forstner bit, put a drop of Crazy Glue in, and press in the dot. Then level it with the wood with a file, not sandpaper, and polish. Even without the glue, the dots are tight, so don't test fit them. The often-seen method of drawing X's between the frets to mark center is not accurate at all, draw a centerline and then mark crosses with a ruler or even just a Mk I eyeball.

5.0

Stumac black plastic dots

By
(Customer's Reviews)


Great product and easy to use. Will purchase these again !

Showing 3 of 8 Read more reviews >>


Shown on page 37 of our latest catalog.