Herringbone Rosette

4.5
  • 14 Reviews
  • Write a review
Buy more, save more!

Herringbone Rosette

Item # 1504
In stock, ready to ship!

$9.44

3 or more $7.46
+
 
Total:
Qty:
Scroll to Top

Herringbone Rosette

Black/white 3-ring set for an acoustic guitar soundhole.

Inside diameter: 4-9/32" (108.74mm)
Outside diameter: 5-3/4" (146.05mm)
Thickness: 3/64" (1.19mm)

The thin outer rings are 0.081" (2.06mm) wide, the center ring is 0.302" (7.67mm) wide.

Note: These rosettes are not continuous circles. Commonly installed with the ends of the rings trimmed, butted and covered by the fingerboard.


Customer Reviews

  • EXCELLENT PRODUCT
  • GOOD PRODUCT
  • AVERAGE PRODUCT
  • FAIR PRODUCT
  • POOR PRODUCT
Write a review
4.5
  • 4.64 average rating from 14 reviews
Sort by
5.0

Herringbone rosette

By
(Customer's Reviews)


I inlaid just the main herringbone section into a dreadnought guitar kit. Used a small finger plane to level to the top. Sanded smooth with 320 grit. Beware of black dust pentetrating the surrounding top wood. Vaccumm thoroughly prior to finishing.

5.0

excellent!

By
(Customer's Reviews)


Superb quality of product, customer service, & speed of delivery. This is the first time I have used Stewmac, - so pleased, have already placed a 2nd order for some quality tooling!

5.0

Resizing

By
(Customer's Reviews)


Like Mr Poliski I needed to resize the herringbone rosette. I found a method that worked very well for me; I diluted som PVA glue with warm water in a shallow bowl. By soaking the rosette in the glue/water mixture for a few minutes it became pliable and it was no problem to fit it into the smaller diameter channel. For safe measure I clamped a pice of acrylic over the rosette until the glue had set. The herringbone rosette turned out really nice on a parlor sixed guitar...

Showing 3 of 14 Read more reviews >>


Shown on page 35 of our latest catalog.