nice to shop where everything is at reach

After putting the Fret Rocker on my Line 6 Variax, it was obvious my guitar needed to go in for fret work. It was bad! The Variax is my practice guitar, and as I'm a prolific string bender, I managed to wear the frets down (unbeknownst to me) here and there over the entire fret board. My guitar plays SO much better because I was able to detect an issue I would not really have known about. Highly recommended!

Didn't think I needed this tool until I used it. Finds rockers easily, and with string spacers, allows spot levelling quickly.

Thanks stew mac

I was chasing a buzz and thought I'd have to run the guitar in to the shop. With none nearby, this saved me some time and money. Turns out the frets are fine. For whatever reason, once I replaced the saddle, I can set the guitar up the way I like and no buzz!

A bit pricey, but well made and very useful tool. Before ordering, I was concerned that the metal thickness would not be adequate - it's perfect so no problem with that. Recommended.

I bought the Fret Rocker a few days back and used it today 4/1/17. It works great, and boy it definitely found several frets sitting a little higher. I highly recommend this tool if you are doing your own work.

Another must have for any luthier or guitar/bass tech. Don't drop it! Sharps edges and pointy ends can't cause minor cuts so I suggest you round the edges a bit and keep a flat surface in the middle. Again, a must have.

Opening a new repair shop this past year I wanted to equip myself with top notch tools (tired of home made) once and for all...StuMac truly came through with this Fret Rocker! Precision cut for any fretboard fit, I use it constantly.

The products works very well but I think it is overpriced for a piece of metal with 4 sides.