Close

Japanese Flush-cut Saw

5.0
  • 4 Reviews
  • Write a review

Japanese Flush-cut Saw

Item # 3614
In stock, ready to ship!

$26.79

+
 
Total:
Qty:
Scroll to Top

Japanese Flush-cut Saw

About This Item

Flexible fine-cut blade in an efficient handsaw. Cuts dowels flush for relocating tuners or bridge studs.

This versatile handsaw reflects the legendary craftsmanship, simplicity and efficiency of traditional Japanese woodworking tools. It's perfect for trimming dowel plugs when you're relocating tuners or bridge studs: the thin flexible blade lets you raise the handle for clearance, while keeping the cutting edge flat to trim the dowel close to the surface. Finely-crafted traditional pull-cut teeth make flush-cutting jobs fast, clean and efficient.

The Japanese Flush-cut Saw features a high quality .015"-thin alloy steel blade with 6-1/4" (158.75mm) cutting edge. The 7" (177.80mm) traditional bamboo handle gives this saw a comfortable weight that makes it enjoyable to use.


Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
5.0
  • 5.00 average rating from 4 reviews
Sort by
5.0

Muy buen serrucho

By

Verified Buyer


Corte limpio , al ras y muy liviana. Escelente !!!!,

5.0

Got plugs?  You need one of these.

By

Verified Buyer


This saw works nicely to cut off plugs when you have to redrill holes. Cuts flush. With some care to keep it truly flat where it rides on the face, there is little or no scratching. Since I was doing it on a finished surface, I used a bit of tape to protect the surface, but the tape didn't get torn. It was then easy to use a razor blade with tape on corners (see Dan's drop fill video) as a scraper to take them all the way down to flush with the finished top.

5.0

saved my neck

By

Verified Buyer


I always wanted one of these saws and recently had a reason to buy one. I've had an old Ibanez A/E guitar with the headstock broken clean off of the neck. Someone had tried to do a repair and it was a mess. I cleaned it, glued and clamped it up. Then I drilled two 1/4" holes and used dowels for extra strength. With the flush cut saw, I was able to make clean cuts to remove excess dowel on both sides. This is a great saw!


Paul
So Royalton VT

5.0

Great saw

By

Verified Buyer


This is a great little saw. Very sharp and cuts quick on the pull stroke. I use it to cut the excess end grafts flush. Works great.