Teflon Fret Dam

5.0
  • 25 Reviews
  • Write a review
Buy more, save more!

Teflon Fret Dam

Item # 0487
In stock, ready to ship!

$4.98

3 or more $4.23
+
 
Total:
Qty:
Scroll to Top

Teflon Fret Dam

For cleaner refret jobs!
Pulling old frets can chip a fretboard: keep the slots clean and glue-free for repairs.

It's hard to avoid a few fingerboard chips when pulling out old frets. A piece of this .020" non-stick Teflon® in the fret slot will help keep your epoxy or super glue out of the slot as you replace or fill the chips. It pulls out easily after the glue is dry. You'll do a cleaner job, save work, and make refretting easier. The .020" x 6" x 6" (.508mm x 152.4mm x 152.4mm) sheet can be trimmed with scissors to the re-usable sizes you need.

A word from Grit Laskin, the King of Inlay:
"My inlay work frequently necessitates large cavities shockingly near to fret slots. In the past, I had no choice but to let epoxy spill over into the slot, requiring me to melt it out, afterward, with a heated saw tip. Then, along came my new best friend, StewMac's Fret Dam. This saves me so much work and completely eliminates the potential for accidental damage of the fret slots, the inlay or the fretboard binding. Now, I won't do a single inlay project without it!"

Teflon® is a registered trademark of DuPont.


Trade Secrets!

Cleaning up after sloppy fretwork: fixing chips in the fingerboard

Erick Coleman's got a neck to fix, including a broken peghead. One thing leads to another, and it turns out the toughest job is hiding the fretboard chips left by the last repairman to work on this guitar.

Customer Reviews

  • EXCELLENT PRODUCT
  • GOOD PRODUCT
  • AVERAGE PRODUCT
  • FAIR PRODUCT
  • POOR PRODUCT
Write a review
5.0
  • 4.76 average rating from 25 reviews
Sort by
5.0

time saver on chips

By
(Customer's Reviews)


These fret dams work well to keep your fret slots clean while being in a place that will leave you a good straight edge for replacing the fret after repairing the chipped edges on the side of fret slots that happen when pulling frets

5.0

great washers too

By
(Customer's Reviews)


Found a new use for mine, I used a ball peen hammer and pinged out washers for my stew mac guitar vise, much smoother operation now, in my opinion anyway.

5.0

dam your work

By
(Customer's Reviews)


i use for clamping so that glues wont stick on my clamps.

Showing 3 of 25 Read more reviews >>


Shown on page 14 of our latest catalog.