Low-friction files for fret ends.
Sold individually or SAVE when you buy the set of both files.
The Fret Beveling File is the fast, accurate way to put a uniform 35° bevel on fret ends after installing new frets. With a quick, smooth motion, this file angles the fret ends and makes them ready for fret dressing and polishing. Available in either 3-3/4" or 7-1/2" filing lengths.
This 1-1/2" x 1-3/4" block (two lengths are available) holds a removable fine-tooth flat file at the proper 35° angle to bevel all the fret ends along the edge of the fingerboard. The block is made of low-friction material for smooth, easy filing. The 3-3/4" model is for short fingerboards (mandolins, for example), and for spot-filing partial refrets. It's also useful for working on used instruments with necks that aren't straight.
|This product is made exclusively for Stewart-MacDonald by|
Works on stainless frets, too!
All of our tools are suitable for use on stainless-steel fretwire, with the exception of our Fret Tang Nippers and Fret Cutters. Modern stainless-steel fretwire is known to be harder than the traditional nickel-silver blends, but our own shop experience indicates the wire does not cause premature wear of files or sandpapers.