Chip Stoppers, Set of 2

4.0
  • 15 Reviews
  • Write a review

Chip Stoppers, Set of 2

Item # 1158
In stock, ready to ship!

$9.95

+
 
Total:
Qty:
Scroll to Top

Chip Stoppers, Set of 2

Fewer chips, cleaner refrets, less work. Tired of gluing back fingerboard chips after pulling up old frets? Our steel Chip Stoppers™ work with our Fret Puller to minimize chip-out.

Chip Stoppers are a clever solution from Don MacRostie here at StewMac, and a big hit in our shops.

The problem with refrets is, any pulled fret might yank a piece of fingerboard up with it. Then if you're lucky, you'll manage to glue each chip back in.

Chip Stoppers press down on the fingerboard as the Fret Puller takes frets out. You get fewer chips, and cleaner refrets. Too bad we didn't think of this twenty years ago — imagine the hours we all would have saved!

Here's how they work:
Heat the fret as usual, with a chisel-tip soldering iron to soften glue under the fret.

Now lift the end of the fret, getting under it with the jaws of the Fret Puller. As soon as it starts coming out, slide the Chip Stopper into place; the .033" x 3" slot fits around the fret tang. Now you can walk the Fret Puller down the length of the fret, lifting it out as the Stopper protects the wood underneath.

Most often, you'll use the .020" Chip Stopper. Sometimes the .010" will suit you better, and you can also combine them for a .030" total thickness.


Customer Reviews

  • EXCELLENT PRODUCT
  • GOOD PRODUCT
  • AVERAGE PRODUCT
  • FAIR PRODUCT
  • POOR PRODUCT
Write a review
4.0
  • 3.87 average rating from 15 reviews
Sort by
5.0

Excellent results

By
(Customer's Reviews)


It has improved my refret work as I don't get chips to fix now. I tested it removing the frets with and without chip stopper from an 80's Epiphone fingerboard (a slightly dry one). I got some minor chips without chip stopper but no chips when using it. Works great. Of course I have to heat frets just before removing them.

1.0

I'm not impressed.

By
(Customer's Reviews)


These seemed like a good idea at the time, so I just had to have them. However, I found them to be more of a nuisance and simply slowed down the process without making too much of a difference in preventing chips or not. You actually need three hands if you use these when heating-up frets and holding the fret pullers as well. So, unless I can find a better way to used them with improved results they'll reside in the junk drawer.

5.0

Simple, practical.

By
(Customer's Reviews)


Another nice option to have at our disposal. "Give me a lever long enough and a fulcrum on which to place it, and I shall move the world." - Archimedes. This is the fulcrum. And it doesn't leave a mark.

Showing 3 of 15 Read more reviews >>


Shown on page 15 of our latest catalog.