Waverly Tuner Drill Jig Instructions

For Waverly Guitar Machines


I-4858

4858-1

The Waverly Tuner Drill Jig quickly locates mounting screw holes for Waverly guitar and ukulele tuners, as well as Grover Sta-Tites. It also keeps the drill bit perpendicular to the peghead for straight, accurate hole drilling.


Depending on your peghead shape and preference, choose how the tuners will be positioned:

Parallel with the edge of the peghead.

4858-parts.jpg

Parallel to the top of the peghead.

4858-parts.jpg

Parallel to the center of the peghead.

4858-parts.jpg

Place a strip of low tack masking tape down the center of the back of the peghead. Measure and carefully mark out the centerline on the tape. Align the jig parallel to the center-line.

4858-1

4858-1This jig requires a 5/64" drill bit.¬° ¬°Measure 13/16" from the bottom of the bit and mark this location with tape or a stop collar to avoid drilling too deep.


Drill the mounting screw holes using a hand drill and repeat for each tuner.