Compound Radius: Explained

An explanation of compound radius fretboards.


A-COMPOUNDRADIUS


On any fretboard, the tops of all the frets need to be aligned, either in a straight line or in a slight curve (called "relief"). Uneven fret heights are not acceptable, nor is too much curve, nor a reverse curve ("backbow"). All of these will cause playing problems. Any frets that sit above or below this ideal line will result in buzzing problems.

Some fretboards are flat from side to side, and many more are radiused (rounded):
Radius vs. flat
Guitar Player Repair Guide

Relief examples




With a flat fretboard, the strings can run at any angle and always be at a consistent height above the fret tops.

Flat example



A radiused board is uniformly curved its full length, as if it were the top of a cylinder. With a cylindrical fretboard surface, all the strings must be parallel to each other in order to keep a consistent height above the fret tops.
Cylinder example



See what happens when a string is turned at an angle to the cylinder:

Cylinder example

Typically, guitar strings are not parallel: they're closer together at the nut, and they spread wider apart at the bridge. For this reason, a fretboard should not be a cylinder. The strings would rise too far off the fretboard at some points. For comfortable playing, the fretboard needs to taper along with the strings, starting wide at the bridge and converging toward the nut.

When you combine this idea of converging strings with a radiused fretboard surface, you get a cone shape:
Cone example

Straight lines (strings) following a cone's surface will not be parallel. They'll be tapered (converging to the point of the cone), the way we want our guitar strings to be. If they follow any other line, they'll create playing problems or string buzz too:

We refer to these conical fretboards as "compound radius" fretboards. 

Cone example
Now that we see that the fretboard needs to be conical for lowest action, we can also see that the spread of the strings and the changing radius of the surface are interconnected. Once you determine the radius at the nut and the spread of the strings, the radius at the bridge is determined by those values.

These photos show exaggerated radii, of course, to show the principle. A guitar string that's just a few thousandths of an inch too high or low will make a big difference in playing action and fret buzz.




How to determine a radius at any point on a fretboard

Fret Work Step By Step

1. Using the spacing of the two E-strings at the nut and the 12th fret, extend the lines until they converge. Measure from the point of convergence to the nut and you will have "X" or the focal length. X is then used in the remaining formulas.

X = Distance from the nut to the Origin (focal point)
Rn = Fingerboard radius at the nut
Rd = Fingerboard radius at "D" (a certain distance from nut)
D = Arbitrary distance from the nut

Compound radius theory

2. The second formula assumes that you have already determined X, the location of the Origin of the cone. This solves for the radius at any point along the fingerboard represented by the value D.

3. The third formula, to find the point D where the radius equals a known value, is written as #3.

Compound radius theory