Close

Pickup Height Screw for Bass

4.0
  • 12 Reviews
  • Write a review
Buy more, save more!

Pickup Height Screw for Bass

Item # 3029-B
In stock, ready to ship!

$0.54

25 or more $0.27
+
 
Total:
Qty:
Scroll to Top

Pickup Height Screw for Bass

About This Item

1-3/8" (34.93mm) Phillips roundhead, for Fender bass.

#2 woodscrew thread.
Recommended pilot hole 1/16" (1.5mm)
Recommended clearance hole 7/64" (3mm)


Customer Reviews

  • Excellent
  • Good
  • Average
  • Fair
  • Poor
Write a review
4.0
  • 4.08 average rating from 12 reviews
Sort by
5.0

Right Part for the job.

By

Verified Buyer


I could not find any screws that fit for installing my pickups. The old screw heads were starting to strip out, so I went looking for replacements. StewMac had the screws. Thanks StewMac!

1.0

I would not buy again

By

Verified Buyer


Considering these are advertised as screws for bass pickups, they are a fraction smaller diameter than most pickup or bass manufacturers use. Also the head diameter is smaller, these barely got the job done for me only because it's a new build. I expect that if you were to try and use these as a direct replacement on a repair job, they would not work without plugging the existing body holes and resizing. Unfortunately, I have to say in the future I'll have to stick with my previous supplier on this item.

3.0

OK

By

Verified Buyer


These work fine.
But after installing them on a Fender-style bass, I realized I prefer the chromed/sleeved Fender-style screws.

5.0

Perfect!

By

Verified Buyer


Exactly what I wanted

5.0

Parts

By

Verified Buyer


Easy, painless,& prompt.

5.0

Excellent for the shop

By

Verified Buyer


I am so glad

5.0

Bass pickup height adjustment screws

By

Verified Buyer


Work perfectly, as expected from Stewmac.

4.0

Long screws

By

Verified Buyer


They are great. They are the same as all StewMac screws, they're tough, look good and cost too much. But where else are you gonna find them? My advice is to buy in bulk and save a bit.

2.0

Worst quality of metal

By

Verified Buyer


Worst quality of metal that I've seen... Even if use proper bit and pilot hole 1 of 3 get slipped... For that price it's not expectable.

4.0

It's a screw

By

Verified Buyer


Make sure to use the proper size pilot hole with the correct driver and you'll have no problems.

Showing 10 of 12 Read more reviews >>


StewMac PDF Catalog, page 49 See Pickup Height Screw for Bass
on page 49 of our StewMac Digital Catalog