Case Handle

  • 7 Reviews
  • Write a review

This heavy-duty plastic handle can be mounted using screws or case rivets (not included).

Read more

Case Handle

Item # 1639
In stock, ready to ship!


6 or more $3.44
12 or more $2.96
Quantity Discount Prices apply when you buy multiples of the same item number.
Total: $0.00
Quantity: 20


This heavy-duty plastic handle can be mounted using screws or case rivets (not included).

1/8" (3.18mm) diameter mounting holes. 1-3/8" (34.93mm) mounting hole spacing on each plate; inner mounting hole spacing is 3-3/16" (80.96mm).

Ratings & Reviews

Case Handle

  • Based on 7 Reviews
Write a review

Fits as a replacement for Taylor molded guitar case

By Mark van Stolk from Germantown, tn
(Customer's Reviews) Thursday, January 03, 2013

The handle on my Taylor molded guitar case broke and Taylor suggested I get a new case. I found the handle at and it looked about the same. It arrived, but the mounting hardware required a flat surface, the case was at an angle. I just removed the pins and attached the plastic part to the existing hardware and it was a perfect fit - much better then a new case!


By chris rochow from Youngstown, Ohio, USA
(Customer's Reviews) Friday, September 14, 2012

Nice! Well made. Love them!

Fix those old Case Handles

By Lawman-Mike from West Des Moines Iowa
(Customer's Reviews) Wednesday, August 15, 2012

OK..I know you like the look of rope or extension cord handles on your old cases. Now for the rest of us that want to use our vintage cases properly, Stew Mac sells these great replacements. I have used them on vintage as well as newer cases. Easy to install with rivets, they look like they belong on your case. I have fixed lots of cases with these. They work great. Lawman-MIke


By Dingobass from Perth, Australia
(Customer's Reviews) Wednesday, August 08, 2012

Not the best looking handle I have seen, but it does the job.

Replacement for Fender bass case

By Bob B from Dearborn Heights Michigan
(Customer's Reviews) Friday, December 02, 2011

It's almost an exact replacement for Fender's molded cases. The biggest difficulty will be removing what's left of the old handle without destroying the case. I used screws and nuts to attach the new one: Nickel plated are preferred. A handle is a handle. It's up to you to make it look good.

Great Handle, but...

By Hofner72 from Oro valley, AZ
(Customer's Reviews) Saturday, October 08, 2011

The handle is an exact replacement for my broken one, but doesn't provide the real replacement rivets to make a Professional looking repair. What am I to do now? Pop rivets are not the right way, and I wouldn't want to see them on my case. Does anybody know where to find the right rivets for this case handle?

Easy Fix

By Pirate Pete from Cornwall England
(Customer's Reviews) Thursday, June 30, 2011

I am no DIY expert but this handle easily fixed a guitar case for a Fender Hendrix Strat restoring it to as new it was the exact replacement for the original that I could not get in England. After buying a Pop Riviter it was an easy job to fix. Highly recomended

Shown on page 80 of our latest catalog.