Conductive Shielding Paint

  • 55 Reviews
  • Write a review

Reduces hum, noise and radio interference.
The fastest and easiest way to shield pickup and control cavities. Perfect for tight spots.

Read more
Conductive Shielding Paint 1/2 pint (236.6ml)

1/2 pint (236.6ml)

Item # 0029
In stock, ready to ship!


Conductive Shielding Paint 1 pint (473.2ml)

1 pint (473.2ml)

Item # 0027
In stock, ready to ship!


Total: $0.00
Quantity: 20


Reduces hum, noise and radio interference.
The fastest and easiest way to shield pickup and control cavities. Perfect for tight spots.

When connected to electrical ground, the shielded surfaces help reduce noise, hum and radio interference. It cleans up with water while still wet, and dries overnight.

Brush on two or more coats of this waterbase dark gray conductive paint for best results (let dry between coats). Conductive shielding paint is supplied in a 1/2-pint can, sufficient for shielding several electric guitars, and in a money-saving 1-pint can. We recommend our conductive tape for best results when shielding smooth plastic pickguards.

California Residents: Click here for Proposition 65 information.

Product Instructions

Conductive Shielding Paint Instructions

Directions for using conductive shielding paint.

Ratings & Reviews

Conductive Shielding Paint

  • Based on 55 Reviews
Displaying 6 of 6 1 2 3 4 5 6
Write a review

Stewmac products

By andreluth from Curitiba Paran+í Brazil
(Customer's Reviews) Friday, January 28, 2011

I'm very satisfied with my purchase in Stewmac

I did do more a excellent acquisition


My project is very complete

As you will see in the picture attached!!

Buzz OFF!

By Guitar Maniac from Franklin PA
(Customer's Reviews) Wednesday, January 19, 2011

Excellent for helping to eliminate unwanted Buzz/noise from outside or signal interference. easy to paint guitar control cavity when copper shielding cannot be installed.

Shielding made easy

By Tom Drinkwater from Oakland, Maine
(Customer's Reviews) Sunday, January 16, 2011

I purchased the paint after using the foil tape for a long time. The foil can be difficult to use properly and if not done correctly will only cause problems. This paint is easy to apply, doesn't require additional soldering and seems to create a good shield against outside interference. I am glad that I made the switch.

Great product.

By L Mollard from Saint Louis, Missouri
(Customer's Reviews) Sunday, December 26, 2010

This worked out wonderfully. I put about six or seven coats throughout the interior of the guitar. You also will want to put in a screw with a wire attached to it, and paint over that. This wire will lead to the ground of the guitar. You won't be shielding properly if you don't provide a way for the interference to lead to ground, so be aware of that. You can also later sand down with some fine and very fine grit sandpaper, which makes for a more pleasant look.

If it's not a vintage instrument, I would probably recommend this instead of the copper tape. It's very easy to use, but once it's on, it's staying on.

A real time saver

By Dan McCulloch from California
(Customer's Reviews) Friday, September 24, 2010

Although this stuff seems to be pricey, it really saves a lot of time, not just as a quick way to get a good shield, but with a little planning, it allows you to ground everything without wires going everywhere. Also if you use a good hair bristle brush (not the throw away stiff bristle kind) one coat is plenty...just clean the brush with soap and water asap.

Displaying 6 of 6
1 2 3 4 5 6

Shown on page 50 of our latest catalog.