I had a few bit that came with my Dremel tool and they are 6 flutes. They cut way too slow. These 2 flute bits that I bought from stewMac cuts so much faster, and not rough at all!
These bits are fantastic. They cut much smoother and cleaner than the non-carbide bits. They are a little on the expensive side for the size of, but in the end are certainly worth it once the inlay work is completed and the customers are happy.
The bits worked great and completely took care of the "fuzzy edge" problem. Thanks!
These are great bits, and you can't do any good inlay work without them.
I love the bit I bought so much I plan on getting more sizes. Great!
What beautiful, sharp little guys these are! The cleanest inlay routing I have ever done.
Purchased the 3/32 and the 3/64 to route inlay pockets for a LP standard rosewood fret board. Couldn't be more pleased. Did a test route with the 3/32 but it was obvious that it would be a little to large for the margins and corners and way to aggressive that close up so I opted too use the 3/64 for everything. That little guy cut through that rosewood like the proverbial hot knife in butter. Also used it to undo two MOP inlays fully set up and while I needed to take this a little slower it did the job well. Absolutely no fuzzy edges just as advertised. While $18 is a little rich for something the size of pencil lead I couldn't find it cheaper elsewhere so what's a guy gonna do.
I couldn't have done my first rosette without them.
Now I can do nice and clean inlay routing with these bits
Its great but it can be found in te market for less money...
To add items to your order, select the check box next to the item you want. You can edit the quantity you wish to purchase here, or in Your Order.
To add items to your saved list, select the check boxes next to the items you want. You can edit the quantity you wish to save here, or in your Saved List.